Assembly Instructions; Legs; Transport Wheels - VITO PRO-POWER VISCB20 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

Legs

1. Turn the table saw upside down and lay it down on a
workbench;
2. Secure each leg to the corresponding corner,
following the letters marked on the legs and on the
table. Example: leg A in corner A. Use 4 flat head
screws, 4 spring washers, 4 plate washers and 4 nuts
on each leg;
3. Secure the longitudinal cross bars to the legs using 1
flat head screw, 1 plate washer, 1 spring washer and
1 nut for each leg.
4. Secure the transverse cross bars to the legs using 1
flat head screw, 1 plate washer, 1 spring washer and
1 nut for each leg.
5. Use 4 hex screws, 4 plate washers, 4 spring washers
and 4 nuts to fix the longitudinal cross bars to the
transverse cross bars;
Make sure that the holes longitudinal and
transverse cross bars point upwards for further
assembly of the table extension.
6. Install the rubber feet to the bottom of the legs.
2.
38
3. and 4.
5.

Transport wheels

Tighten the wheels on the rear legs using 2 hex screws,
2 plate washers, 2 spring washers and two nuts on each
leg.