Before You Start Working; While Operating - VITO PRO-POWER VISCB20 Manual De Instrucciones

Do not expose the power tool to rain or use it in wet or
moist environments. The presence of water in a power
tool increases the risk of damage and electric shock to
the user.
Only hold the power tool by its insulated surfaces,
which prevent electric shock if the power tool comes
into contact with hidden wires or power cord during
operation.
Never use the power cord to pull, carry or unplug the
power tool. Damaged power cords increase the risk of
electric shock.
Keep the power cord and plug away from heat sources,
oil, sharp objects and rotary accessories. Check the
condition of the power cord regularly, if it is damaged,
it must be replaced or repaired by a qualified technician.
Never change the power cord plug and use a socket
which is compatible with the plug. Do not use any kind
of socket adaptor.
The use of extension cords to plug in the power cord is
not recommended. However, if you use an extension
cord, you should take some precautions, such as:
▪ If you use the power tool outdoors, use only
extension cords suitable for outdoor use. The use of
a suitable extension cord reduces the risk of electric
shock;
▪ Use only extension cords, plugs and sockets with
grounding;
▪ The cross-section of the extension cord's cables shall
be proportional to the length and with the same
characteristics as or larger than the table saw's
power cord;
▪ Do not use damaged extension cords. Examine the
extension cords before using them and replace if
necessary;
▪ Always unplug the extension cord before removing
the plug from the power tool;
▪ When using an extension cord reel, unroll the cord
completely;
▪ Use extensions cord with a minimum 2.5mm cross-
section;

Before you start working

Individuals who have not read the instruction manual
and are not familiarized with how to operate the table
saw must not use it.
36
To ensure that you work with the power tool safely, you
should take into account a few precautions and
procedures before start-up:
▪ Inspect the power tool before each use. Check that
the attached accessories are assembled correctly and
in good condition. In case there is excessive damage
or wear, replace them;
▪ Check that all fixing screws are properly fastened.
Regular inspection is important to ensure the safety
and performance of the power tool;
▪ After the accessories' assembly and before using the
power tool, test it at full speed at no load for a while.
Check for moving parts misalignment or any other
condition that may affect the table saw operation.
Check that all moving parts rotate smoothly, without
abnormal noises or sparks on the carbon brushes;
▪ Check that the safety devices are in perfect condition
and work properly. Never use the power tool if the
safety devices are missing, inhibited, damaged or
worn out;
▪ Ensure that the ON/OFF switch is OFF positioned
when you connect the power cord. If the ON/OFF
switch is damaged or does not allow the operation of
the power tool to be controlled, it must be repaired
or replaced in order to prevent any accidental start;
Make all adjustments and work necessary for the
correct assembly of the power tool if you have any
questions or difficulties, contact your official dealer.

While operating

Keep third parties away from the power tool's area
of operation. Never work while animals or people,
especially children, are in the danger zone.
Keep the work area clean, organized and well lit (250 to
300 lux light), thus decreasing the risk of accidents.
Always wear personal protective equipment and
clothing. Wearing a visor or goggles, dust mask, hearing
protection, anti-slip safety shoes, long-sleeved clothing,
gloves and helmet properly reduces the risk of injury.