Technical Assistance; Assembly Instructions; Clamping The Sliding Miter Saw To A Workbench; Plastic Side Supports - VITO PRO-POWER VISCME210 Manual De Instrucciones

Technical Assistance

Your sliding miter should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts.

ASSEMBLY INSTRUCTIONS

Clamping the sliding miter saw to a workbench

1. Place the miter saw on a level workbench;
2. Secure the base by tightening the bolts, washers and
nuts in the mounting holes.

Plastic side supports

1. Remove the bolts;
2. Fit the plastic side support (11) and tighten the bolts;
3. Repeat the process for the other side.

Clamp

1. Insert the support pin into the hole and tighten the
bolt;
2. Insert the clamp (2) in the support pin and tighten the
fixing bolt.
The clamp can be mounted at both ends of the
fence (1).

Dust and shavings collection bag

1. Press the retaining spring and place the collection
bag (5) on the dust and shavings duct.
2. Release the spring and check that the collection bag
is correctly fitted.
Empty the dust bag frequently to prevent the
duct from being clogged.

Miter locking handle

Thread the miter locking handle all the way.
32

Changing the blade

1. Raise the cutting head to an upright position. Pull out
the head lock-down pin (19);
2. Press the blade guard locking lever (7);
3. Rotate the blade guard (9) upwards and loosen the
screw;
4. Press the spindle lock button and rotate the blade
until it locks. Continue to press the spindle lock
button and loosen the screw with the supplied key;
5. Remove the flange and the used saw blade (10);
6. Install the new blade on the inner flange and then the
outer flange. Make sure the blade is correctly fitted;
7. Tighten the screw to the spindle thread;
8. Press the spindle lock button and rotate the blade
until it is locked. Continue to press the spindle lock
button and loosen the screw with the supplied key;
9. Rotate the blade guard upwards and loosen the
screw;
10. Test the saw blade rotation, at maximum speed, to
ensure its correct installation;
Always wear protective gloves when handling and
installing saw blades;