Connection To The Webserver - Grundfos CIM 500 Instrucciones De Instalación Y Funcionamiento

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74

3.5 Connection to the webserver

The module can be configured by means of the built-
in webserver. To establish a connection from a PC to
CIM 500, proceed as follows:
1. Connect the PC and the module using an
Ethernet cable. See the figure below.
2. Configure the Ethernet port of the PC to belong to
the same subnetwork as CIM 500, for example
192.168.1.101, and the subnet mask to
255.255.255.0. See the section on network
settings in the appendix.
3. Open a standard Internet browser and type
192.168.1.100 in the URL field.
4. Log in to the webserver:
User name
Default: admin
Password
Default: Grundfos
The first time you log in, you must set a
unique password. Only a factory reset of
CIM 500 can reset the password to
Grundfos.
CIM 500 connected to PC via Ethernet cable
Related information
A.1. Webserver configuration
10
3.5.1 Connection to the webserver using GRM IP /
GiC
To access the webserver via GRM IP / GiC, you need
to connect your PC parallel to the router (RJ45 port 1)
at CIM 500 RJ45 port 2. Look at the router webserver
which address the router assigns to CIM 500. Then
use this IP address for the webserver access.
See also the section on security in the appendix and
the section on webserver configuration.
You can use both ETH1 and ETH2 to
establish a connection to the webserver.
You can access the webserver while the
selected Industrial Ethernet protocol is
active.
When you select "GRM IP" or "GiC", the
connected router automatically assigns an
IP address to the module via DHCP.
CIM 500 connected to PC and cellular router
Related information
A.1. Webserver configuration
3.1 Security
Tabla de contenido
loading

Tabla de contenido