Fein CG13-125V Manual De Instrucciones página 23

Character Unit of measurement,
international
n
/min, min
r/min
P
W
1
P
W
2
U
V
f
Hz
M...
mm
Ø mm
mm
mm
mm
mm
mm
kg
L
dB
pA
L
dB
wA
K...
m/s
m/s
h,AG
m/s
h,DS
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
°
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have
thoroughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 054 06 1). The documents mentioned should
be kept for later use and enclosed with the power tool,
should it be passed on or sold.
Unit of measurement,
national
-1
, rpm, rpm
W
W
V
Hz
mm
mm
mm
mm
mm
mm
mm
kg
dB
dB
2
m/s
2
m/s
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
min, m/s
°
Explanation
Rated speed
Power input
Output
Rated voltage
Frequency
Size of metric thread
Diameter of a round part
Ø
D
Ø
H
T=Thickness of grinding/cutting disc
Ø
D
M=Thread for clamping flange / application
tool
l=Length of mounting thread
Ø
D
M=Thread for clamping flange / application
tool
T=max. wire length
Ø
D
M=Thread for clamping flange / application
tool
Weight according to EPTA-Procedure 01
Sound pressure level
Sound power level
Uncertainty
2
Vibrational emission value according to
EN 60745 (vector sum of three directions)
2
Mean vibrational value for angle grinding
2
Mean vibrational value for sanding with sand-
ing sheet
Basic and derived units of measurement from
the international system of units SI.
2
Please also observe the relevant national industrial
safety regulations.
Intended use of the power tool:
Hand-guided angle grinder for dry grinding, wire brush- ing and cutting of metal and stone as well as for drilling
tiles in weather-protected environments without the
use of liquid coolants, using the application tools and
accessories recommended by FEIN.
This power tool is also suitable for use with AC gener-
ators with sufficient power output that correspond to
the Standard ISO 8528, design type G2. This Standard
is particularly not complied with when the so-called dis-
tortion factor exceeds 10 %. When in doubt, please
refer to the generator instruction/specification guide.
=Max. diameter of grinding/cutting disc
=Diameter of mounting hole
=Max. sanding pad diameter
=max. cup brush diameter
=Max. tile drill diameter
en
23