Econo Cool Operation - Mitsubishi Electric MSZ-GL06NA Manual De Instrucciones

S
MART SET OPERATION
A simplifi ed set back function enables to recall the preferred (preset) setting with
a single push of the button. Press the button again and you can go back to
the previous setting in an instance.
1
Press during COOL, or HEAT mode to select
SMART SET mode.
2
Set the temperature, fan speed, and airfl ow direction.
• The same setting is selected from the next time by simply pressing
• Two settings can be saved. (One for COOL, one for HEAT)
• Select the appropriate temperature, fan speed, and airflow direction ac-
cording to your room.
• Normally, the minimum temperature setting in HEAT mode is 61°F
(16°C). However, during SMART SET operation only, the minimum tem-
perature setting is 50°F (10°C).
Press again to cancel SMART SET operation.
• SMART SET operation also is cancelled when the MODE button is
pressed.
Note:
Example of use:
1. Low energy mode
Set the temperature 4°F (2°C) to 6°F (3°C) warmer in COOL and cooler in
HEAT mode. This setting is suitable for unoccupied room, and while you are
sleeping.
2. Saving frequently used settings
Save your preferred setting for COOL and HEAT. This enables you to select your
preferred setting with a single push of the button.
E
CONO COOL OPERATION
Swing airfl ow (change of airfl ow) makes you feel cooler than stationary airfl ow.
So, even though the set temperature is automatically set at 4°F (2°C) higher, it is
possible to perform cooling operation with keeping comfort. As a result, energy
can be saved.
1
Press during COOL mode

ECONO COOL operation.

The unit performs swing operation vertically in various cycles according to the
temperature of airflow. Set temperature is set 4°F (2°C) higher automatically.
.
Press again to cancel ECONO COOL operation.
• ECONO COOL operation is also cancelled when the VANE button is
pressed.
T
IMER OPERATION (ON/OFF TIMER)
1
Press or
(ON timer) :
(OFF timer) : The unit turns OFF at the set time.
* or blinks.
* Make sure that the current time is set correctly.
2
Press (forward) and
time of timer.
Each press changes the set time 10 minutes forward/backward.
• Set the timer while
Press or
Note:
• ON and OFF timers can be set together.
• If power failure occurs while ON/OFF timer is set, see
page 5, 6 to start
during operation to set the timer.
The unit turns ON at the set time.
Page 4
(backward) to set the
or is blinking.
again to cancel timer.
mark indicates the order of timer operations.
page 9 "Auto restart function".
En-8