Technical Menu - Installation - Ferroli Connect CRP Manual De Instalacion Y Uso

6.2

TECHNICAL mENU - INSTALLATION

Using the and
TION menu and confirm with the
From this menu it is possible to:
1. Mange the various zones.
In particular, for each zone, it will be possible to:
• Pair the zone to an RF device
MENU >> TECHNICAL >> INSTALLATION >> ZONES MANAGER >> (CHOOSE THE DESIRED ZONE) >>
RF DEVICE >> PAIRING
NOTE To pair an RF device (
page 106
• Set the "Climatic curves"
MENU >> TECHNICAL >> INSTALLATION >> ZONES MANAGER >> (CHOOSE THE DESIRED ZONE) >>
CLIMATIC CURVES
NOTES Define the climatic curves for the heating and cooling modes
For the correct setting of climatic curves (
CURVES" on page 107
• Configure the type of system
DIRECT ZONE
(MENU >> TECHNICAL >> INSTALLATION >> ZONES MANAGER >> (CHOOSE THE DESIRED ZONE)
>> HYDRAULIC CONF >> DIRECT ZONE)
MIXING ZONE
(MENU >> TECHNICAL >> INSTALLATION >> ZONES MANAGER >> (CHOOSE THE DESIRED ZONE)
>> HYDRAULIC CONF >> MIXING ZONE)
For correct configuration (
NOTE
scrupulously followed.
• Change the zone name
(MENU >> TECHNICAL >> INSTALLATION >> ZONES MANAGER >> (CHOOSE THE DESIRED ZONE)
>> CHANGE NAME)
2. Add a zone
3. Delete a zone
4. Calibrate the Connect CRP temperature sensor
5. Reset the Connect CRP
102
EN
buttons, select the INSTALLA-
button.
R F D E V I C E
HYDRAULIC CONF
cod. 3542B380 - Rev 00 - 05/2022
T E C H N I C A L
I N S T A L L A T I O N
S Y S T E M T Y P E
D I G I T A L I N P U T
I N S T A L L E R
fig. 66
see "ANNEX 1 - PAIRING AN RF DEVICE" on
)
CLIMATIC CURVES
the hydraulic system configuration must be
),
see "ANNEX 3 - CLIMATIC
)