Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly
IMPORTANT NOTE: Please refer to the end of this manual for all photos
that are referenced in parentheses in the instructions below.
Unpacking the Product
• Remove everything from the box – pet stroller with pet carrier included, front wheels(2), rear
wheels(2), and documents (not shown).
• Discard all packaging materials properly including plastic coverings.
• DO NOT allow children to play with any packaging materials.
I WARNING:
product. No tools required.
Unfolding the Pet Stroller
• Orient the pet stroller with the handle facing upward. (1)
• Remove the pet carrier from the stroller and put it aside for later assembly. (2)
• Release the safety latch located on the left side of the pet stroller. (3)
• Pull upwards on the handle. (4) Keep pulling until the pet stroller is fully erected and the locking
mechanism has fully engaged.
• Gently push downward on the handle to ensure that the pet stroller is completely opened and
locked before ANY use of the product.
I WARNING:
while unfolding. ALWAYS ensure the locking mechanism is
fully engaged when the pet stroller is in the opened position.
This action will prevent collapse of the pet stroller. Possible
pinching hazard – Be careful when unfolding the pet stroller.
Installing/Removing the Front Wheels
• Slide one front wheel into the front wheel housing until it clicks into place. (5) Repeat for the other
wheel. Pull on the wheels to ensure they are installed properly.
• To remove the wheel, press the metal release button on the back of the front wheel housing and
pull the wheel away from the pet stroller. (6)
Installing/Removing the Rear Wheels
• Install a rear wheel by sliding the axle into the hole in the wheel hub until it clicks into place. (7)
Repeat for the other wheel. Pull on the wheels to ensure they are installed properly.
• To remove the wheel, push the release button on the rear wheel hub and pull the wheel from the
pet stroller. (8)
Assembling the Pet Carrier
• For the pet carrier that was previously put aside, lift up on the sides of the carrier to fully expand it.
(9)
• Keeping it fully expanded, gently place it on the floor or a table. (10)
• Remove the pad and pad support from the carrier and put them aside.
• Open the fabric pocket on the bottom of the carrier and locate the support legs with the fabric
loops attached. (11)
• With one hand braced against the bottom of the carrier, use your other hand to firmly pull the loop
on one of the support legs towards one end of the carrier until the support leg fits into the groove
Adult assembly is required for this
Keep children away from pet stroller
5
Tabla de contenido
