Steinberg Systems SBS-RT-500NN Manual De Instrucciones página 21

CAUTION!: Make sure that the support structure on which the unit will move is
strong enough to withstand the weight of the load
and the unit. Do not mount the unit on a support structure that cannot be verified
as to its load-bearing capacity and strength.
The responsibility for mounting on a support structure and for the support
structure itself rests with the user.
Special care must be taken when attaching the unit to the supporting structure, and
all conditions for safe operation must be ensured in order to avoid hazards resulting
in possible personal injury.
The maximum deviation from the horizontal of the cart track should not exceed
0.3%.
ASSEMBLY OF THE UNIT
Assembly and operation of the machine should be performed by a qualified
person.
• Measure the preferred track width of the machine, making sure to
maintain a gap of approximately 2mm between the flange of the machine
wheel and the rail on which it will run.
Adjust the track width:
•
- Loosen the hex nuts, spacing the side plates to the preferred width
(keeping them parallel).
- Fill in the gaps on both sides of the side plates with washers, making
sure that the load carrier is centered.
- Screw on the previously removed hexagon nuts. Make sure they are
tightened securely.