Parameter Menu - Roger Technology B70/2B Instrucciones Y Advertencias Para El Instalador

12

Parameter menu

PARAMETER
PARAMETER
Automatic closure after pause time (from door completely open)
Disabled.
Number of door closure attempts after photocell is triggered.
Automatic door closing after mains power outage
Disabled. The door does not close automatically when mains power is restored.
rameter
Selecting step mode control function (PP)
The automatic closing timer restarts if a new step mode command is received.
Step mode commands are ignored while the door is opening. This allows the door to open completely
and prevents the door from closing when not required.
If automatic closing is disabled (
manoeuvre
The automatic closing timer does NOT restart if a new step mode command is received.
Step mode commands are ignored while the door is opening. This allows the door to open completely
and prevents the door from closing when not required.
If automatic closing is disabled (
manoeuvre
Flashing warning signal for 1 to 10 seconds prior to every manoeuvre.
Condominium function for partial open command (PED)
Enabled. Partial commands are ignored during door opening.
Enabling operator present function
Disabled.
Enabled. The open (AP) or close (CH) button must be pressed continuously to operate the door. The
door stops when the button is released.
56
VALUE
in extended mode). The door closes in "position recovery" mode (see chapter 16).
.
.