Tabla de contenido
Idiomas disponibles
Idiomas disponibles
•
Do not use force when inserting the battery
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Adjusting depth of cut
1
CAUTION:
•
After adjusting the depth of cut, always tighten the
lever securely.
Loosen the lever on the side of the rear handle and move
the base up or down. At the desired depth of cut, secure
the base by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
KICKBACKS which can cause personal injury.
Bevel cutting
1
Loosen the clamping screw on the bevel scale plate on
the front of the base. Set for the desired angle (0° - 50°)
by tilting accordingly, then tighten the clamping screw
securely.
Sighting
1
B
2
001351
1. Lever
001368
1. Clamping screw
2. Bevel scale
plate
2
001386
1. Base
2. Cutting line
A
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the B
position with it.
Switch action
2
CAUTION:
•
Before inserting the battery cartridge into the tool,
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
push in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
Electric brake
This tool is equipped with an electric blade brake. If the
tool consistently fails to quickly stop blade after switch
trigger release, have tool serviced at a Makita service
center.
The blade brake system is not a substitute for lower
guard. NEVER USE TOOL WITHOUT A FUNCTIONING
LOWER GUARD. SERIOUS PERSONAL INJURY CAN
RESULT.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing saw blade
1
7
001407
1
1. Lock-off button
2. Switch trigger
001428
1. Shaft lock
2. Hex wrench
2
Tabla de contenido
