Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Cutting off the sheet
009472
CAUTION:
Always disconnect the hose before cutting off the
•
sheet.
Tear off the output sheet in the direction of the arrow
when using the sheet collated nails.
MAINTENANCE
CAUTION:
Always disconnect the air hose from the tool
•
before
attempting
maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may result.
Jammed nailer
009477
009473
CAUTION:
Always disconnect the air hose and remove the
•
nails from the magazine before cleaning a jam.
When the nailer becomes jammed, do as follows:
Open the magazine cap and remove the nail coil. Insert a
small rod or the like into the ejection port and tap it with a
hammer to drive out the nail jamming from the ejection
port. Reset the nail coil and close the magazine cap.
to
perform
inspection
Drain tool
Remove the hose from the tool. Place the tool so that
the air fitting faces down to the floor. Drain as much as
possible.
Cleaning of tool
Iron dust that adhere to the magnet can be blown off by
using an air duster.
Cap
When not in use, disconnect the hose. Then cap the air
fitting with the cap.
009193
Storage
When not in use, the nailer should be stored in a warm
or
and dry place.
Maintenance of compressor and air hose
1
004317
After operation, always drain the compressor tank. If
moisture is allowed to enter the tool, It may result in
poor performance and possible tool failure.
Keep the air hose away from heat (over 60°C, over
140°F), away from chemicals (thinner, strong acids or
alkalis). Also, route the hose away from obstacles which
it may become dangerously caught on during operation.
Hoses must also be directed away from sharp edges
and areas which may lead to damage or abrasion to the
hose.
Thinner
004320
8
1. Cap
1
1. Drain cock
Stove
Tabla de contenido
