Stihl RE 90.0 Manual De Instrucciones página 35

7 Connecting to a water source
1
► Screw the water filter (1) onto the water supply
and tighten by hand.
Connecting the water hose
The water hose must meet the following require‐
ments:
– The water hose has a diameter of 1/2".
– The water hose is between 10 m and 25 m
long.
► Connect the water hose to a tap.
► Turn on the water tap fully and flush the water
hose with water.
Sand and dirt will be flushed out of the water
hose. The water hose will be vented.
► Turn off tap.
2
1
► Push the coupling (1) onto the connector (2).
The coupling (1) engages with an audible
click.
► Turn tap fully on.
► If the spray lance is attached to the spray gun:
Remove the spray lance.
► Squeeze the spray gun trigger until an even
water jet is delivered from the spray gun.
► Release the spray gun trigger.
► Lock the spray gun trigger.
► Attach the spray lance.
► Attach the nozzle.
0458-002-9821-B
Removing the water hose
2
1
► Turn off tap.
► To unlock the coupling: Pull the ring (1) or
twist and hold it.
► Pull the coupling off the connector (2).
7.2 Connecting the high-pressure
washer to another water supply
The high-pressure washer can draw in water
from water butts, storage tanks and flowing or
still rivers and lakes.
So that the water can be drawn in, the height dif‐
ference between the high-pressure washer and
the water source must not exceed the max. suc‐
tion lift (a), 18.1.
The appropriate STIHL suction set must be used.
The suction set includes a water hose with a
special coupling.
Depending on the market, the appropriate STIHL
suction set may be included with the high-pres‐
sure washer.
Connecting the water filter
If the high-pressure washer is operated with
water containing sand from water butts, cisterns
or from flowing or still rivers and lakes, a water
filter must be connected to the high-pressure
washer.
Depending on the market, the water filter may be
included with the high-pressure washer.
English
a
35