Propass Factory Recommended Settings Guide - TYCROP ProPass 180 Top Dresser Manual Del Operador

ProPass Factory Recommended Settings Guide

ProPass
Hitch position
Twin Spinner settings
Pendant
Tow vehicle rpm
Ground speed
Note: Different materials vary in the size of their particles, causing variations in the spread pattern. Before top dressing the
required area, test new materials by spreading them in an open area away from bystanders.
Operating Instructions
All manuals and user guides at all-guides.com
TYCROP Manufacturing Ltd.
Settings for Best Performance
Level
Paddle position: factory setting
Twin Spinner: Leave on during top dressing.
Conveyor belt: Turn off between passes.
Full throttle
5 to 8 km/h (3 to 5 mph)
ProPass 180 Top Dresser Operator's Manual
Additional Performance
Use the multi-position hitch to raise or lower
the ProPass for maximum performance.
Test the spread pattern in a neutral area,
then make very small adjustments.
At the start of each new load, it takes 1 to 3
seconds for material to reach the Twin
Spinner and begin discharging.
An engine at full rpm provides the maximum
hydraulic flow. Always warm up the engine
and the hydraulic system before use.
Travel at about the speed of a fast walk.
Page 27