Removing A Truck Mount Propass From The Storage Stand; How To Operate The Controls And Options On Sh Models; Flow Control Valve For Conveyor Belt; Figure 28: Hydraulic Connections - TYCROP ProPass 180 Top Dresser Manual Del Operador

15. Connect the ProPass hydraulic lines to the work
vehicle's hydraulic connections (at the rear; see
Figure 27). The line with the one-way flow check
valve connects to the return connection on the work
vehicle.
Figure 27: Hydraulic connections
16. On SH models connect the on/off pendant and place
it in the cab of the work vehicle. Ensure that both
switches are off.
17. On EH models connect the control pendant.
Removing a Truck Mount ProPass from
the Storage Stand
1. Park the work vehicle in the storage spot for the
ProPass.
2. Disconnect the electrical connection from the work
vehicle (Figure 25).
3. Disconnect the ProPass hydraulic lines from the
work vehicle (Figure 27).
4. On SH models remove and store the on/off pendant.
5. On EH models remove and store the control pendant.
6. With the work vehicle in neutral gear, set the parking
brake and start the engine.
7. Using the vehicle lift cylinder, raise the front of the
ProPass high enough for the front storage stand legs.
8. Turn off the engine.
Page 22
All manuals and user guides at all-guides.com
TYCROP Manufacturing Ltd. ProPass 180 Top Dresser Operator's Manual
9. Insert the front and rear storage stand legs and secure
them with locking pins.
10. With the work vehicle in neutral gear, set the parking
brake and start the engine.
11. Using the vehicle lift cylinder, lower the front of the
ProPass until the front storage stand legs begin to
touch the ground.
12. Turn off the engine.
13. Raise the two rear storage jack stands until the
pressure is off the rear mounting pins.
14. Remove the rear mounting pins. (If necessary,
wiggle the ProPass.)
15. With one hand, hold the lift cylinder. With the other
hand, remove the lift cylinder's locking pin. (If
necessary, wiggle the lift cylinder control.)
16. Rest the lift cylinder in the appropriate location on
the work vehicle's frame.
17. Walk around the ProPass. Ensure that it is clear of
the work vehicle's frame and secured within each of
the four storage stand legs.
18. With the work vehicle in neutral gear, set the parking
brake and start the engine.
19. Release the parking brake and slowly drive the work
vehicle forward, away from the ProPass truck-mount
on the storage stand (Figure 23).
: Do not climb under or
W
ARNING
perform work on the ProPass while it is
on the storage stand.
How to Operate the Controls and
Options on SH Models
: Before operating the
W
ARNING
ProPass, read and understand the entire
Operator's Manual and all safety decals.

Flow Control Valve for Conveyor Belt

A hydraulic flow control valve controls the speed of the
conveyor belt. To unload the ProPass quickly, set the
Operating Instructions