Disconnecting The Propass From The Tow Vehicle; Installing A Truck Mount Propass From The Storage Stand; Figure 24: Installing The Propass Onto The Work Vehicle (Or Uninstalling It Onto The Storage Stand) - TYCROP ProPass 180 Top Dresser Manual Del Operador

backwards or not work at all. Test the hydraulics
before operating the ProPass for the first time.
: The hydraulic lines, the power cable,
I
MPORTANT
and the pendant cables must not drag on the ground
during operation. Avoid locations where they could
become pinched or cut.
8. For SH models, plug the four-prong electrical cord
into the tow vehicle. On EH models attach the
control pendant with the 12 pin plug.
9. On SH models place the on/off pendant within reach
of the driver's seat. Ensure that both switches are off.
10. Check the hydraulic oil level in the tank and add
more to fill it, if necessary. (See the tow vehicle's
owner's manual).
Disconnecting the ProPass from the
Tow Vehicle
1. Park the tow vehicle and the ProPass on dry, level
ground.
2. Set the parking brake on the tow vehicle, shut off the
engine, and remove the key.
3. Place blocks under two wheels of the ProPass (front
and back).
4. Relieve the pressure from the hydraulic system.
5. Disconnect the hydraulic hoses, coil and store them
on the front of the ProPass.
6. On SH models disconnect the four-prong power cord
from the tow vehicle. On EH models disconnect and
remove the control pendant.
7. On tow-behind chassis Turn the jack stand 90
degrees (clockwise) to the down position to support
the ProPass.
8. On TYCROP direct connect chassis move the jack
stands to the front of the machine and turn them
90 degrees until the bottom of both jack stands points
to the ground.
9. Lift the ProPass with the jack stand(s) until the
weight is off the tow vehicle's draw bar. Pull out the
hitch pin.
Page 20
All manuals and user guides at all-guides.com
TYCROP Manufacturing Ltd. ProPass 180 Top Dresser Operator's Manual
10. Ensure that there is no further connection between
the ProPass and the tow vehicle.
Installing a Truck Mount ProPass from
the Storage Stand
1. With the vehicle in neutral gear and the parking
brake set, start the work vehicle's engine.
2. Release the parking brake, look over your left
shoulder, and slowly reverse the work vehicle
towards the ProPass truck-mount on the storage
stand (Figure 23).
Figure 23: Installing the ProPass onto the work
vehicle (or uninstalling it onto the storage stand)
3. Stop when the left rear mounting bracket on the
frame rail of the work vehicle is located directly
under and between the mounting bracket arms at the
left rear of the ProPass (Figure 24).
Operating Instructions