Ryobi RY48RM76A Manual De Instrucciones página 13

The cutting height is set too low.
The motor stops while
cutting.
The battery charge is low.
The battery charge is low.
The side discharge interlock switch is not
pressed by the side discharge chute.
The blades do not
rotate. The blade engage knob is down.
The operator is not fully seated.
There is build-up of debris under mower.
The blades do not The reverse mode option is o .
rotate while moving in
reverse. The blade engage knob is down.
The product won't The battery charge is low.
reach full speed.
The blades continue to The safety interlock system is not
turn after the operator functioning correctly.
leaves the seat without
engaging the parking
brake.
The headlights are o .
The headlights are not
working.
The headlights are damaged.
The battery cells are bad.
The battery does not
charge.
The cable connections are poor.
Raise the cutting height.
Charge the battery.
Charge the battery.
Push down the side discharge chute, and make sure that it fully
presses the side discharge interlock switch.
Pull up the blade engage knob to activate the blades.
Fully sit down on the seat.
Clean the underside of the mower deck.
Press the reverse mode button to activate reverse mode.
Pull up the blade engage knob to activate the blades.
Charge the battery.
Ensure that the safety interlock system seat plug is fully connected.
If the blades still won't stop, have the product serviced by an
authorised service centre only.
Press the headlight button to turn on the headlights.
Replace the headlights.
Replace the battery.
Check and clean all the battery connections.
13
Original Instructions
EN
ES
IT
NL
PT
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR