HTW SETA Manual Del Usuario página 36

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

STEP 6
WARNING: Remove the protective cover before assembly.
Note: If necessary for proper alignment of the reflector sections,
loosen each bolt before further assembly and retighten after
aligning the sections.
STEP 6-1
Slide two reflector panels together.
Insert an M6 X 10 bolt (II). Slide a washer Φ 6 (HH) over the
threaded end of the M6 X 10 bolt (II) and screw on the cap nut (JJ)
loosely.
Used hardware
Washer Ø6
Screw M6x10
Cap nuts
STEP 6-2
Slide the reflector plate over the reflector panels.
Insert an M6 X 10 bolt (II). Slide a washer Φ 6 over the threaded end
of the M6 X 10 bolt (II) and screw on the cap nut (JJ) loosely. Repeat
the procedure to complete the assembly of the four sections. of the
bolts on the rolled edge.
STEP 7
7-1. Lift the tank shell up and rest it on the post plate.
7-2. Connect the regulator to the fuel tank and tighten it with a spanner
spanner fitting.
7-3. Connect the threaded end of the gas inlet hose to the regulator.
7-4. Place the LPG gas tank on the bracket.
14
STEP 6
STEP 6-1
STEP 6-2
STEP 7
Controller
Gas tank
Tabla de contenido
loading

Este manual también es adecuado para:

Estgas14000seta

Tabla de contenido