HTW SETA Manual Del Usuario página 24

Read the instructions before installation and use
- This appliance must be installed and the gas cylinder stored in
accordance with current regulations;
- Do not obstruct the ventilation holes of the cylinder housing;
- Do not move the appliance when it is in operation;
- Close the valve on the gas cylinder or regulator before moving
the appliance;
- The tube or flexible hose must be changed within the prescribed
intervals;
- Only use the type of gas and the type of bottle specified by the
manufacturer;
- In case of violent wind, pay special attention not to tilt the
appliance;
The injector installed in this appliance is not designed to be removed. The
injector is only assembled by
Do not connect the gas cylinder directly to the appliance without a regulator.
The flexible hose must be approved by the EN16436: 2014 standard.
The regulator must comply with EN16129: 2013, the regulator outlet pressure
must match the values ​ ​ o n the data plate.
The replaced regulator must at least correspond to national regulations.
- Use a 30 mbar regulator for butane / propane in category I3B / P (30).
- Use a 30 mbar regulator for butane in category I3 + (28-30 / 37).
- Use a 37 mbar regulator for propane in category I3 + (28-30 / 37).
- Use a 50 mbar regulator for butane / propane in category I3B / P (50).
WARNING
2