Fein Slugger JCM 200 QX Instrucciones De Uso página 20

en
20
Switching the gear setting
(figure 14).
With the gear switch, you can select the
speed and thus the torque.
Adjust the gear setting only when the
machine is at a complete stop or when the
motor is running down.
Set the switch to gear 1 to work at low
speed with high torque. This setting is suit-
able for drilling with large drill bit diameters
and for tapping.
Set the switch to gear 2 to work at high
speed with low torque. This setting is suit-
able for drilling with small drill bit diameters.
JCM 200 U, 1. Gear
JCM 200 QX,
JCM 200 auto
JCM 256 U 1. Gear
JCM 200 U, 2. Gear
JCM 200 QX,
JCM 200 auto
JCM 256 U 2. Gear
JCM 200 QX 1. Gear
JCM 200 U, 1. Gear
JCM 200 auto
JCM 256 U 1. Gear
Drilling capacity in
steel - TCT in steel - high speed
(core drill bit)
27 – 50 mm
1 1/16 in – 2 in
27 – 65 mm
1 1/16 in – 2 5/8 in 1 1/16 in – 1 3/16 in
12 – 26 mm
7/16 in – 1 1/16in
12 – 26 mm
7/16 in – 1 1/16in
Max. diameter
for reaming
≤ 16 mm
≤ 5/8 in
≤ 23 mm
≤ 7/8 in
≤ 25 mm
≤ 1 in
Fig.14
Drilling capacity Drilling capacity in
steel (HSS)
(core drill bit)
21 – 40 mm
3/16 in – 1 5/8 in
21 – 45 mm
12 – 20 mm
7/16 in – 3/4 in
12 – 20 mm
7/16 in – 3/4 in
Max. diameter for
counterboring
≤ 31 mm
≤ 1 3/4 in
≤ 50 mm
≤ 2 in
≤ 50 mm
≤ 2 in
steel - high speed
steel (HSS)
(twist drill bit)
16 mm – 23 mm
5/8 in – 7/8 in 1/4 in – 5/8 in
16 – 25 mm
5/8 in – 1 in 1/4 in – 6/8 in
1,5 – 15 mm
1/16 in – 5/8 in
1,5 – 15 mm
1/16 in – 5/8 in
Tapped hole
M6 – M16
M6 – M20
–
–