Idiomas disponibles
Idiomas disponibles
en
18
Adjusting the stroke range
(figure 11).
Hold the power tool firmly
CAUTION
with one hand when releas-
ing the two fastening levers.
To move the fastening levers over each
other, pull a fastening lever outward and
then turn the fastening lever in 45° steps.
Loosen both fastening levers with the other
hand.
Adjust the desired stroke range.
Tighten both fastening levers again.
Adjusting the working position
(JCM 256 U) (figure 12).
Release the fine-adjustment clamping lever.
Adjust the desired position. The drill stand
can be moved toward the front or rear on
the magnetic foot, and can be turned toward
the right and left.
Tighten the clamping lever again.
Fig.12
