-
-
G
Appearance and Function of Remote Control
1
2
4
G
Appearance and Function of Remote Control
D
AIR FILTER
The air conditioner is equipped with a screen filter to remove the bigger dust
particles.
The screen filter has to be cleaned 2x a week. Clean the air filter with a neutral
detergent in lukewarm water (40ºC) and allow to dry slowly.
To take out and place back the screen filter.
4
60
While in heating mode, press the SLEEP key to set the temperature. It
decreases 1 ºC after an hour and at most decreases 2ºC after 2 hours.
Press the SLEEP key again can cancel the setting."
NOTE!
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner. The cooling will switch off
when the room temperature is lower than the set temperature. Air
circulation will however continue to work on the set level. When the
room temperature rises above the set temperature, the cooling will
work again.
5
6
7
8
NOTE!
- Do not drop the remote control.
- Do not place the remote control in a location exposed to direct
sunlight.
Sleep indicator
Timing indicator
1. Temperature selector up
2. Fan speed selector
3. Sleep mode selector
4. Auto Swing selector
5. Mode selector
6. Hourly programming
7. On/Off switch
8. Temperature selector down
Mode
Heating indicator
Fan indicator
Dehumidification
indicator
Cold indicator
Swing indicator
Wind speed
High speed indication
Medium speed
indication
Low speed indication
Full water indicator