CFX3
7.10
Using the battery protection
The device is equipped with 3-stage battery protection. The battery protection pre-
vents excessive discharging when the device is connected to a vehicle starter battery
or maximises the use of a supply battery.
If the cooler is operated when the vehicle ignition is switched off, the cooler switches
off automatically as soon as the supply voltage falls below a set level. The cooler will
switch back on once the battery has been recharged to the restart voltage level.
A
NOTICE! Damage hazard
When switched off by the battery protection, the battery will no longer
be fully charged. Avoid starting repeatedly. Ensure that the battery is
recharged.
I
NOTE
When the cooler is supplied by a starter battery, select the battery
protection mode "MEDIUM" or "HIGH". If the cooler is connected to a
supply battery, the battery protection mode "LOW" is ideal.
➤ Proceed as shown (fig. h, page 12).
7.11
Setting the display's brightness
➤ Proceed as shown (fig. i, page 12).
7.12
Switching on or off the compartments
(only CFX3 75DZ, CFX3 95DZ)
You can activate each zone individually or both of them.
➤ Proceed as shown (fig. j, page 13).
7.13
Using the ice maker (only CFX3 55IM)
I
NOTE
• Independent of the main compartment's temperature setting, the
ice maker zone is designed for making ice cubes if the ice maker is
switched on.
• The cooler's energy consumption increases with ice maker on.
Therefore you should switch off the ice maker if it is not needed.
• The factory setting for the ice maker is OFF.
EN
Operation
29