Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CAUTION:
After adjusting the depth of cut, always tighten the
•
clamping nut securely.
Sighting
B
A
009559
For straight cuts, align A with your cutting line on the
workpiece. For 45° bevel cuts, align B with it.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and returns
to the "OFF" position when released.
1
009558
For tool with lock button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop. For continuous operation, pull
the switch trigger and then push in the lock button. To
stop the tool from the locked position, pull the trigger fully,
then release it.
For tool with lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
1. Switch trigger
2. Lock button
2
Installing or removing diamond wheel
1
2
009563
Hold the outer flange with the wrench and loosen the hex
bolt clockwise with the hex wrench. Then remove the
hex bolt, outer flange and diamond wheel.
To install the wheel, follow the removal procedure in
reverse. Always install the wheel so that the arrow on the
wheel points in the same direction as the arrow on the
blade case.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
1
2
009565
CAUTION:
Use only the Makita wrench and hex wrench to
•
install or remove the wheel.
OPERATION
009561
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the wheel making any contact. Then
turn the tool on and wait until the wheel attains full speed.
Now simply move the tool forward over the workpiece
surface, keeping it flat and advancing smoothly until the
cutting is completed. Keep your cutting line straight and
your speed of advance uniform.
CAUTION:
THIS TOOL SHOULD ONLY BE USED ON
•
HORIZONTAL SURFACES.
6
1. Outer flange
2. Wrench
3. Hex wrench
3
1. Inner flange
2. Diamond wheel
3. Outer flange
3
4. Hex bolt
4
Tabla de contenido
