Metz MECABLITZ 44 AF-1 digital Manual De Instrucciones página 97

Pentax
The flash unit supports Pentax is wireless
P–TTL Remote System in slave flash mode.
This means that one or more slave flash
units can be controlled remotely from a
master or controller flash unit on the
camera (e.g. mecablitz 58 AF-2P digital)
or from the camera master.
Slave flash unit 44AF-1 is always set to all
remote channels 1, 2, 3 and 4.
Samsung
The remote slave flash mode is not
supported by Samsung cameras.
Sony
The flash unit supports the wireless Sony
remote system in the "CTRL" and
"CTRL " modes.
+
This means that one or more slave flash
units can be controlled remotely from a
master or controller flash unit on the
camera (e.g. mecablitz 58 AF-2S digital)
or from the camera master (depending on
camera model).
Slave flash unit 44AF-1S is always set to
all remote channels 1, 2, 3 and 4.
Applicable to all versions
(except Samsung):
The slave flash units must be able to recei-
ve light from the master or controller flash
unit via the integrated sensor
te use.
The flash unit in the camera can functi-
on as a master or controller flash unit
depending on camera type. Further
information regarding settings on the
master or controller flash unit can be
found in the respective operating
instructions.
Configuration procedure for remote slave
flash mode
• Switch on the flash unit by pressing the
button .
• Press the "SL" button on the flash unit
to configure the remote slave SL flash
mode. The setting is effective immediate-
ly and saved automatically.
Checking the remote flash mode
• Position the slave flash unit according to
subsequent shooting requirements.
A flash unit stand S60 (accessories)
should be used when setting up the
slave flash unit.
for remo-
+
SL
M
TTL
97
k