Mechanical Release; Position Recovery Mode; Initial Testing; Maintenance - Roger Technology B70/1B Instrucciones Y Advertencias Para El Instalador

14

Mechanical release

In
for BR41 automated door system).
Activating one of the two limit switches immediately reacquires the position.
15

Position recovery mode

After a mains power outage or after mechanically releasing the door, if the door is not completely open or completely
closed the next time a command is received, the control initiates a position recovery procedure:
• The door starts a low speed manoeuvre.
•
• The control unit recovers the installation data during this procedure. Warning! During this procedure, do not use any
controls until one of the two limit switches is reached.
• Activating one of the two limit switches immediately reacquires the position.
16

Initial testing

• Turn on the power supply.
• Check that all connected controls are working correctly.
• Check travel and deceleration.
• Check that the impact force is correct.
•
or any obstacles which may increase the risk of crushing.
• Disconnect from mains then reconnect and switch on again. Check that the door is repositioned correctly both when
• Check the limit switch settings. During opening, the door must stop before it hits the door open stop. During closure,
cm), and remain activated until the end of the manoeuvre.
• Check that the door closes completely and does not push with excessive force against the door closed stop.
• Perform a number of complete door closure manoeuvres, from both the fully open position and an intermediate
position.
17

Maintenance

Perform scheduled maintenance every 6 months.
Check cleanliness and function.
If the unit contains dirt, moisture, insects or other foreign matter, disconnect from mains power and clean the board
and the housing.
Repeat the initial installation test procedure after cleaning.
If any corrosion is found on the printed circuit board, evaluate if it is necessary to replace the board itself.
18

Disposal

removing the product correctly and safely. This product consists of numerous different materials. Some of
waste management facilities indicated by local legislation applicable for this category of product.
Do not dispose of this product as domestic refuse. Observe local legislation for differentiated refuse
collection, or hand the product over to the vendor when purchasing an equivalent new product.
Warning! Some parts of this product may contain substances that are harmful to the environment or dangerous and
which may cause damage to the environment or health risks if disposed of incorrectly.
52