Cutting - Kamikaze KV 362 Manual De Uso

ELECTRIC PRUNING SHEARS
Caution: Do not sway the pruner from the left to right in order not
to damage the edge of blade during the resume process of blade.
Check the working frequency of the blade in order to verify the good
working condition.

14. CUTTING

Wear suitable work clothes such as boots with non-slip soles, sturdy
long trousers, gloves and goggles.
Wear protection gloves
Wear eye protection
Risk of cutting and severe injuries
Warning!
In particular situations of very hard use, the blade and the handle could reach
high temperatures. It is recommended to handle the pruner with care, using
protective gloves.
• When ready to cut, place the blade
on the branch to be cut and press
the trigger;
• When operating the tool, keep the
other hand and any other part of
your body at a minimum distance of
15cm from the blade;
• Keep all other people at a minimum
distance of 1.5m
www.kamikazevolpi.com
46
ELECTRIC PRUNING SHEARS
• Blade will be hurt or jammed if cutting bigger branch forcedly.
• Do not move the tool during the pruning shear cutting, it can cause danger.
• Do not use the device in rain or humidity environment.
• If the pruners stop working during long term use and you hear 4 fast
beeps, this is an indication of undervoltage protection which means the
battery is depleted. Please charge as soon as possible.
• Switch off the device after use and remove the battery from the pruner.
• If no operation for 10 minutes, the pruner switches off automatically.
Caution: please check battery charge level or blade sharpening
when cutting is difficult or not smooth.
14.1. CUTTING CONTROL MODE
The KV362 electric pruning shears has two cutting control modes:
Progressive cutting control.
Non-progressive cutting control
PROGRESSIVE CUT MODE
The machine starts by default in progressive cut mode, this means that the
blade moves according to the depth of the trigger actuation, that is, the blade
moves progressively proportional to the trigger movement.
NON-PROGRESSIVE OR IMPULSE CUTTING.
To change the cutting control mode, you must close the blade and hold the
trigger for 2 seconds, until you hear a sound indicating that it has changed
to pulse mode, then you must press the trigger again 2 times in one second
of time . In pulse mode the blade moves in one stroke when the trigger is
pressed.
In the progressive cutting control, the blade moves according to the depth of
the trigger drive, that is, if the trigger is activated halfway, the blade moves
progressively halfway through its opening.
www.kamikazevolpi.com
47