Electrical Connection; Electrical Requirements - Gaggenau BS 470 612 Instrucciones De Instalación

6.4 LAN connection to the home network
This appliance is network capable. You can connect the
appliance to the home network using a LAN cable. A LAN
cable is not included and needs to be purchased sepa-
rately.
Establishing the LAN connection
Before installing the appliance, insert a LAN cable into
1.
the socket on the back of the appliance.
Use the strain relief to secure the LAN cable in place.
2.
Connect the LAN cable to a network.
3.
7 Electrical connection

Electrical connection

Read these instructions to safely connect your appliance
Electrical connection
to the electrical supply.
7.1 Electrical requirements
Make sure your electrical installation supports the follow-
ing requirements.
WARNING
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
▶
ON accidentally.
IMPROPER GROUNDING CAN RESULT IN A RISK OF
ELECTRIC SHOCK.
Consult a qualified electrician if the grounding instruc-
▶
tions are not completely understood, or if doubt exists
as to whether the appliance is properly grounded.
If the power cord is too short, have a qualified electri-
▶
cian install an outlet near the appliance.
DO NOT USE AN EXTENSION CORD.
▶
This appliance must be supplied with the proper voltage
and frequency and connected to an individual, properly
grounded branch circuit, protected by a circuit breaker or
fuse. To know the circuit breaker or fuse required by your
model, see the rating plate to find the wattage consump-
tion and refer to the ratings table to get the circuit breaker
or fuse amperage.
WARNING
Local codes may vary.
Installation, electrical connections and grounding must
▶
comply with all applicable local codes.
Electrical supply
Circuit breaker
Conduit
Electrical rating
Circuit specifications: 208/240V AC, 60Hz, 15A, 3- wire,
¡
dedicated grounded circuit from panel.
The outlet must be properly grounded in accordance
¡
with all applicable codes.
It is the responsibility of the installer to comply with local
¡
codes. If no local codes are applicable, wire in accor-
dance with the National Electrical Code (or Canadian
Electrical Code), ANSI/NFPA 70 - latest edition.
Minimum bend radius of the flexible conduit is
¡
6" (152 mm).
The electrical supply should be a 3-wire single–phase
¡
AC. Install a suitable junction box (not furnished).
7.2 Routing the electrical conduit cable
Requirements
A hole in the cabinet has been prepared to route the
¡
electric conduit from the oven to the junction box.
Serviceability must be maintained. Do not shorten the
¡
electric conduit cable. Route the electric conduit cable
in a way to permit temporary removal of the oven.
The electrical conduit cable swivels where it is con-
▶
nected at the oven. Rotate the electric conduit cable up-
ward or downward and direct it through the prepared
hole in the cabinet.
Electrical connection en-us
208/240V AC, 60Hz, 3–wire
15 Amp
48" flexible 3-wire
2.7 kW @ 208V
3.6 kW @ 240V
7