HTW CAL2000VER Manual De Usuario página 8

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

INTRODUCTION
Thank you for purchasing this heater. Each unit has been manufactured to ensure
your complete safety and reliability. Before first use, please read these
instructions carefully and keep them for future reference.
INSTALLATION
This heater does not require installation, as it is a portable appliance.
It is not recommended to use these portable appliances in the bathroom.
Place the unit on a flat, unobstructed surface.
Plug the power cord into a grounded electrical outlet in your home.
OPERATION
Using the top switch, you can select the heat output (1000 or 2000W) and stop the
unit.
Right control, Start-up (speeds):
When in position "0" it is switched off.
When in position "1" it is running at a power of 1000W.
When in position "2" it is running at a power of 2.000W.
Left control, Thermostat (adjustable):
If it is all the way to the left, the heater will switch off.
The further you turn the thermostat to the right, the higher the cut-out temperature
will be.
Please adjust the thermostat to obtain an optimal room temperature, as well as to
achieve high energy saving efficiency by maintaining a comfortable temperature.
This heater is provided with an overheat safety device, which means that if the
heater accidentally covers the air inlet or outlet, this overheat protector will stop
the fan, so that the heater can be used again, proceed as follows:
1. Set the speed control to position "0" (stop).
2. Unplug the power cable and check that all the air inlets and outlets are free.
3. Wait for the heater to cool down, for a period of not less than 10 minutes.
4. Reconnect the power cord to the power socket.
5. Set the speed control to the "1" heat position, check that the heater is
working properly.
5
Tabla de contenido
loading

Tabla de contenido