IKEA CIRKULERA Manual página 13

EN
Assembly of the Burner Caps
Make sure that all of the surface burner caps and
surface burner grates are installed correctly and at
the correct locations.
Remove all packing material from the cooktop area.
Make sure burner caps are properly placed on the
surface burners.
The burner head has a hole which fi ts over the ig-
nitior. Make sure the head fi ts snugly before placing
the burner caps.
Unpack the burner grates and position them on the
cooktop after the burner heads and caps are prop-
erly installed.
On round-style burners, the burner cap lip
(Figure 3) should fi t snug into the center of the
burner head and rest level. Refer to Figure 4 for
correct and incorrect burner cap placement.
Figure 3: Burner cap (A) burner head (B) ig-
nitor (C) orifi ce (D)
Figure 4: Cap placement
BEFORE SETTING SURFACE CONTROLS
Once in place, you may check the fi t by gently slid-
ing the burner cap from side to side (Figure 5) to
be sure it is centered and fi rmly seated. When the
burner cap lip makes contact inside the center of
the burner head you will be able to hear the burner
cap click
A
Figure 5: Gently move cap for proper place-
ment
B
• Please note that the burner cap should not
C
move off the center of the burner head when
sliding from side to side.
D
• Do not use the surface burners without the
burner caps properly installed. Improperly
seated burner caps may prevent burners from
lighting or cause uneven fl ame and heating.
• Missing pieces or improper installation may
lead to spills, burns, or damage to your range
and cookware.
• Never place fl ammable items on the cooktop.
Do not allow spills, food, cleaning agents, or any
other material to enter the gas orifi ce holder
opening.
Always keep the burner caps and burner heads in
place whenever the surface burners are in use.
Never place fl ammable items on the cooktop.
IMPORTANT
CAUTION
13