Charging The Rechargeable Battery - Carrera RC Power Wave 300001 Instrucciones De Montaje Y De Servicio

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16

Charging the rechargeable battery

First connect the Carrera RC rechargeable
1
battery to the battery charger supplied. The
connection terminals between the battery
and the charger are designed to prevent
connection with the wrong polarity. Connect
the charger to a power source.
When the battery is properly connected and
charging normally, the red LED is constantly
lit. Once the battery is fully charged, the red
LED switches to green. The battery can now
be disconnected and installed in the Carrera
2
2
RC boat.
The boat is now ready for use.
After use, the battery must be allowed to cool
down for at least 20 minutes before it can be
fully recharged. Failure to observe this
pause may damage the battery.
RED = Charging
GREEN = Ready
Always recharge the battery immediately after use to prevent its becoming deep
discharged. Recharge the battery occasionally (suggested every 2-3 months).
Failure to treat the battery as described above can lead to its becoming defective.
Rechargeable batteries are only to be charged by adults.
Installing the rechargeable battery
Using a screwdriver, remove the cover of the
1
battery compartment in the Carrera RC boat.
Connect the end of the cable from the
2
Carrera RC boat with the charged battery.
Put the battery in place.
Replace the compartment cover using
a screwdriver.
Fitting in the batteries
Press the release button, then take the
1
battery compartment out of the controller.
Take care when inserting the batteries that
2
the polarity is correct. Diff erent types of bat-
teries or new and used batteries are not to
be mixed. Push the battery compartment
back into the controller until it clicks into
place.
All manuals and user guides at all-guides.com
On contact with the water the status LED next to the ON/OFF-switch lights up con-
tinuously, indicating that a charged battery is being used.
When the boat battery is almost empty, the status LED will start to fl ash regularly.
Please head for the shore immediately and change the battery.
• Before launching from the bank, make sure the boat and the controller are con-
• Avoid constant motor operation.
• When the boat battery is almost empty, the status LED next to the ON/OFF-
• After use, remove or disconnect the battery.
• Never run more than 2 batteries down one after the other. After running down
• Always keep the Carrera RC battery stored outside the boat.
• After sailing it, clean the Carrera RC boat carefully
10
Now you can drive the boat
On fi rst using it, the boat must be con-
1
nected with the controller.
A connection can only be made
when the boat is in contact with the
water.
To do this, you fi rst switch on the con-
troller, plug in the battery to the boat,
switch the boat on and then press the
small button located in the battery com-
2
partment until the LED lamp lights up
continuously.
Switch on the Carrera RC boat using
the ON/OFF switch.
Let's practise!
Caution: this boat can reach speeds
1
30km/h
up to 30 km/h.
When fi rst starting, be very careful
when operating the gas pedal. Practice
running slowly for at least two to three
full charges of the battery before you
start practising faster manoeuvres.
nected (see above)
switch will start to fl ash regularly. Please head for the shore immediately and
change the battery.
two fully-charged batteries, a pause in running for at least 20 minutes is essen-
tial.
Tabla de contenido
loading

Tabla de contenido