Ryobi ECO-2335 Manual De Utilización página 26

GB
F D
PROBLEM
Machine does not start.
Motor does not reach full.
Motor stalls, blows fuses,
or trips circuit breakers.
Motor overheats.
Machine is noisy when running.
Wheel hits table.
Wheel does not cut
through workpiece.
Machine vibrates or shakes
excessively.
All manuals and user guides at all-guides.com
E I P NL
TROUBLESHOOTING
CAUSE
1. Power cord not plugged in.
2. Power cord is damaged.
3. Circuit breaker is tripped.
4. Circuit fuse is blown.
5. Switch is damaged or burned out.
1. Voltage from power source
2. Circuit is overloaded.
3. Motor burned out.
4. Fuses or circuit breakers
are wrong size.
5. Extension cord is too long.
6. Switch is defective.
1. Switch is defective.
2. Voltage from source is low.
3. Fuses or circuit breakers are
wrong size or defective.
1. Motor is overloaded.
2. Wheel is being fed into
work too fast.
1. Motor needs attention.
1. Wheel not properly installed.
2. Depth stop setting incorrect.
1. Depth stop setting incorrect.
2. Wheel worn too much.
3. Incorrect cutting operation.
1. Wheel is out-of-round.
2. Wheel is chipped.
3. Wheel is loose.
4. Machine is not secure.
5. Work surface is uneven.
S DK N FIN
English
SOLUTION
1. Plug in cord.
2. Have the cord replaced at your nearest authorized service center.
3. Reset circuit breaker.
4. Replace circuit fuse.
5. Have the switch replaced at your nearest
authorized service center.
1. Request a voltage check.
2. Test on a different circuit or without
anything else on circuit.
3. Have tool serviced and request a voltage
check.
4. Have an electrician replace with
a circuit breaker.
5. Use a shorter extension cord.
6. Have the switch replaced at your nearest
authorized service center.
1. Have the switch replaced at your nearest
authorized service center.
2. Request a voltage check.
3. Have an electrician replace with
a circuit breaker.
1. Request a voltage check.
2. Feed wheel into work slower.
1. Have the motor checked at your nearest
authorized service center.
1. See "Removal and Installation of Wheel"
section.
2. Adjust the depth stop.
See "Depth Stop" section.
1. Adjust the depth stop.
See "Depth Stop" section.
2. Replace with a new 355 mm
abrasive cut off wheel.
3. See "Cut-Off" section.
1. Replace wheel.
2. Replace wheel.
3. Tighten wheel bolt on arbor.
4. Check and tighten all hardware.
5. Relocate and secure on a flat surface.
20
GR H CZ RUS RO PL