Tabla de contenido
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - showerhead
Flow rate - handshower
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
Inspect
the
damage
before
for shipping damage made after the
showerpipe is installed will not be honored.
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Do not install this showerpipe in a steam shower.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• The installation dimensions shown in this installation
instruction are ideal for people of approximately
6' in height. The dimensions can be changed if
required. In this case, the minimum ceiling height
of 89¼" from the standing surface, and all other
measurements, must be changed.
• Make sure that the wall is strong enough to support
the showerpipe. The wall must be reinforced at the
mounting points.
• The area where the top mounting piece is to be
installed must be flat and free of protruding grout
joints, etc.
• The enclosed screws and anchors are suitable for
a solid surface wall. For other wall constructions,
select mounting hardware and reinforcement
suitable for that specific construction.
• This showerpipe requires showerpipe rough
16181181(not included).
2
15 - 75 PSI
120° - 140° F*
2.0 GPM max.
2.0 GPM max.
showerpipe
for
installation.
145 PSI
176°F*
• To prevent scald injury, the maximum output
shipping
temperature of the shower valve must be no higher
Claims
than 120°F. In Massachusetts, the maximum output
temperature can be no higher than 112° F.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Product Safety Notes
• The purpose of the shower arm is to support the
showerhead only. Do not use it to support other
objects.
• Do not use the showerpipe as a grab bar. Using the
showerpipe as a grab bar may result in injury or
product damage. If a grab bar is required, purchase
and install one separately.
Tabla de contenido
