Pedestal Assembly; Base Assembly; Battery Replacement - Bionaire BCH9212 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS
Unpack your heater from the box, being careful
to remove all parts from plastic bags and
remaining packaging. Please save the carton for
off-season storage.
Some models are packed with separate base
and pedestal in the box. Carefully remove all
parts from plastic bags and follow below
instructions for further assembly:

Pedestal Assembly

NOTE: If no pedestal is included in this model,
move to Base Assembly.
Step 1: Snap the two pedestal halves
together. Refer to Figure 1.
Step 2: Run the power cord through the center
of the assembled pedestal. Snap
pedestal into the bottom of the heater
housing. Refer to Figure 2.

Base Assembly

Step 1: If the base is in two halves, snap them
together by sliding slots of one base
half into slots of second base half.
Refer to Figure 3.
Step 2: To assemble the base to the unit
(either one or two-piece base) first
make sure the side marked "Rear" is
facing the back of the heater. Line up
holes of the base with holes on bottom
of pedestal (or heater housing if no
pedestal is included), and secure with
4 provided screws. Refer to Figure 4.
Figure 1
Figure 2
Figure 3
All manuals and user guides at all-guides.com
Figure 5
Step 3:
Step 4:
Remote Control (if applicable)
If your heater comes with a remote control,
unpack the remote control from box. This
includes one lithium battery, CR2025/3V. Please
note this remote control will not work through
walls. Remove battery before discarding the
remote.
NOTE: REMOVE THE PROTECTIVE COVER
FROM THE BATTERY PRIOR TO BEGINNING
OPERATION.

Battery Replacement

1. Locate the battery cover on the back of the
2. Place battery into battery compartment.
3. Slide battery cover closed.
4. For your convenience, a remote control
NOTES:
•
•
•
OPERATING INSTRUCTIONS
1. Place heater on a firm, level surface.
2. Plug heater into a standard outlet. Once
3
Figure 4
Lace the power cord through the cord
minders on the underside of the base.
Refer to Figure 5.
Turn the heater right side up on a flat
level surface prior to beginning
operation.
remote control handset. Slide the battery
cover out with your thumb.
holder is integrated into the back of the
heater housing.
Remove the battery from the equipment
when it is not being used for an extended
period of time.
Remove the used battery promptly.
Do not discard used batteries into household
trash containers. Contact your local
government for disposal or recycling
practices in your area.
plugged in, the Power Light will illuminate.