Using The Pressure Washer - SNOWJOE SUNJOE SPX800-PRO Manual Del Operador

11. Attach the garden hose to a water supply (Fig. 10).
Fig. 10
Connect to water supply
Garden hose
m
WARNING!
Do not connect to potable water main.
m
WARNING!
If connection is made to a potable water
system, the system shall be protected against backflow.
m
WARNING!
The intake water temperature must not
exceed 104ºF/40ºC. The water supply must not exceed
0.7 MPa.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
Operation

Using the Pressure Washer

m
IMPORTANT!
This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
1. Position the washer as CLOSE as possible to the water
supply.
2. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 11).
Fig. 11
3. Make sure the unit is switched off before plugging the unit
into the power outlet.
4. Check that the electrical supply voltage (V) and frequency
(Hz) correspond to those specified on the rating plate.
If the power supply is correct, you may now plug the
pressure washer into the power outlet (Fig. 12).
NOTE: The GFCI may need to be reset when first plugged
into the electric outlet. Press the "Reset" button until
the power light indicator on the GFCI illuminates when
plugged in.
5. Turn the water supply tap on completely.
6. Make sure the safety lock is stowed and in its original
position (Fig. 13), then pull the trigger for a few seconds
until water flow is steady. This will allow air to escape and
discharge any residual pressure in the hose.
Fig. 13
7. Turn the ON/OFF switch to the ON/I position to start the
pressure washer (Fig. 14).
m
CAUTION!
To prevent damage to the appliance, do not
allow it to operate dry. Before starting the appliance, make
sure that it has a stable supply of water.
8
Fig. 12
Reset
Power light
indicator
GFCI
Safety lock
Trigger