Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4.
If electrolyte gets into your eyes,
rinse them out with clear water and
seek medical attention right away. It
may result in loss of your eyesight.
5.
Always cover the battery terminals
with the battery cover when the
battery cartridge is not used.
6.
Do not short the battery cartridge:
(1) Do not touch the terminals with
any conductive material.
(2) Avoid storing battery cartridge
in a container with other metal
objects such as nails, coins, etc.
(3) Do not expose battery cartridge
to water or rain.
A battery short can cause a large
current
possible burns and even a
breakdown.
7.
Do not store the tool and battery
cartridge in locations where the
temperature may reach or exceed
50 ﾟ C (122 ﾟ F).
8.
Do
not
incinerate
cartridge even if it is severely
damaged or is completely worn out.
The battery cartridge can explode in
a fire.
9.
Be careful not to drop or strike
battery.
SAVE THESE
INSTRUCTIONS.
Tips for maintaining maximum
battery life
1.
Charge the battery cartridge before
completely discharged.
Always stop tool operation and
charge the battery cartridge when
you notice less tool power.
2.
Never recharge a fully charged
battery cartridge.
Overcharging shortens the battery
service life.
flow,
overheating,
the
battery
3.
Charge the battery cartridge with
room temperature at 10 ﾟ C - 40 ﾟ C
(50 ﾟ F - 104 ﾟ F). Let a hot battery
cartridge
charging it.
4.
Charge the Nickel Metal Hydride
battery cartridge when you do not
use it for more than six months.
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is switched
•
off and the battery cartridge is removed
before adjusting or checking function
on the tool.
Installing or removing battery
cartridge
002045
Always switch off the tool before
•
insertion or removal of the battery
cartridge.
To remove the battery cartridge, pull out
•
the set plate on the tool and grasp both
sides of the cartridge while withdrawing
it from the tool.
To insert the battery cartridge, align the
•
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Snap the set plate back into
place. Be sure to close the set plate
fully before using the tool to prevent the
battery
cartridge
falling out of the tool.
5
cool
down
1. Set plate
1
2. Battery cartridge
2
from
accidentally
before
Tabla de contenido
