Kenmore 596.57002600 Guía De Uso Y Cuidado página 11

Installation
6. Pull on tubing to confirm
connection is secure.
Connect tubing to frame
with water tubing clamp (C)
and turn on water supply.
Check for leaks and correct
if necessary. Continue to
observe the water supply
connection for two to three
hours prior to moving the
refrigerator to its permanent
location.
7. Monitor water connection for 24 hours. Correct
leaks, if necessary.
Handles
Plastic Handle
To Install:
1. The handles are to be oriented as shown.
2. Align door handle with the door studs.
3. Ensure the large hole in the mounting clip is
positioned down on both ends of the handle.
4. Rotate the handle so that the
handle is flat against the door.
5. Grasp the handle firmly and
slide down.
All manuals and user guides at all-guides.com
Door
Stud
Metal Handle
Materials Needed:
• 3 " Allen wrench
⁄
32
• Gloves to protect hands
Note:
Metal handles can scratch doors.
C
To Remove:
• Loosen set screws in handle using
wrench.
• Repeat the procedure on all screws.
To Replace:
• Align handle with the mounting posts.
• Apply upward pressure to the handle and hold.
• Fully tighten all set screws to secure handle in
place.
3 " Allen
⁄
32
11