Wet/Dry Vac Assembly - Workshop WS0400DE1 Manual Del Usuario

WET/DRY VAC ASSEMBLY

Your vacuum will come out of the box fully
assembled for your convenience.
Please check inside the dust drum for
additional components before using this
product.
To Remove the
Powerhead Assembly:
Grasp the drum latches on both the right
and left side of the powerhead assembly.
Slowly pull the drum latches away from the
dust drum. Lift the powerhead assembly off
the dust drum.
To Reassemble the
Powerhead Assembly:
1. Position the powerhead assembly with
the detachable blower handle of the
unit located above the vac inlet port on
the dust drum.
2. Lower the powerhead assembly onto
the dust drum. Rotate both latches
down until you hear them snap over the
drum latch catches.
Powerhead
Assembly
Dust Drum
Drum Latch (2)
Detachable
Blower Handle
Powerhead
Assembly
Dust Drum
Vac Inlet
Port
Powerhead
Assembly
Dust Drum
Drum Latch (2)
6
Pull Out
And
Lift Up
Rotate
Down