Barrette BOM-34107025 Instrucciones De Instalación página 4

1.
Insert aluminum P-channel inserts into both
gate uprights (Fig. 1).
2.
Insert bottom rail into bottom upright route on
one side only (Fig. 2).
3.
In the gate kit there will be two boards that
are 4 ⁄ ⁄ ⁄ ⁄ " wide, make sure these are your end
1 1 1
8 8
boards. Add left and right U-channels onto the
end boards. Make sure one U-channel is on the
"groove" side of one board and one U-channel is
on the "tongue" side of other board (Fig. 3).
4.
Insert boards starting from left and working right
into bottom rail. (Fig. 3).
5.
a.) For full privacy gates, slide top rail over all
boards and insert top rail into upright route on
same side as bottom rail (Fig. 4).
b.) For lattice top, open picket top and closed
picket top gates, slide middle rail over all
boards and insert middle rail into upright
route on same side as bottom rail (Fig. 5).
4
P-Channels
Gate Uprights
Route
Rail
End Board
U-Channel
Fig. 1
Fig. 2
Fig. 3
U-Channel
Fig. 4
Fig. 5