Troubleshooting - Haier GWT560BW Manual Del Usuario

TROUBLESHOOTING

ERROR CODES
When the washer senses an error all machine operations will stop, a series of 4
beeps will sound and an error code will be shown in the Estimated Time Remaining
display.
ERROR CODE
dO
:DVKHU /LG LV 2SHQ
Ld
(Too Long to Drain
:DWHU
UL
8QEDODQFHG /RDG
LF
7RR /RQJ WR )LOO
FA
(Water Level Sensor
(UURU
F2
(Water Level is Too
+LJK
E5
(Water Temperature
3UREOHP
WASHER DOES NOT OPERATE
r
Check that the power cord is plugged into a grounded 3 prong outlet.
r
Check that the electrical wall receptacle is of proper voltage.
r
Check if the circuit breaker needs to be reset or if the fuse needs to be replaced.
DESCRIPTION
The washer has detected
that the lid is open.
The washer has detected
that it is taking too long
to completely drain water
from the wash tub.
The washer has detected
an out of balance load and
has failed to self correct
the condition.
The washer senses that it
LV WDNLQJ WRR ORQJ WR OO WKH
wash tub or does not read
a change in water level
GXULQJ D OO
The washer has detected
water level sensor errors.
The washer has detected
higher than normal water
levels, automatic draining
has not resolved the issue.
The washer senses that
Hot water is too cold, or
Warm, Cool, Cold, and Tap
Cold water is too hot.
POSSIBLE CAUSE AND SOLUTION
The washer will not start with the
washer lid open. If the lid is opened
during the wash cycle, it may
continue to run. However, when it
reaches a stage that requires the
lid to be closed, the error will occur.
Closing the lid should dismiss
the error and resume normal
operation.
Check to make sure the drain hose
is properly installed. The open end
of the drain hose should not be
submerged in water.
Open the washer lid, redistribute
the load, close the lid, and the
washer will resume operation.
Check to make sure that the
water hoses are connected to the
washer, there are no kinks in the
hoses, and that the supply valves
are fully opened.
Call for Service.
Call for Service.
Check to make sure that your
hot water heater is supplying hot
water. Check to make sure that
the water hoses are connected to
the proper valve; hot to hot, cold
to cold.
21