Toro 58603 Manual Del Operador página 10

7. For each wheel, slide in the pin and secure the
wheel with the bolt.
Figure 7
1. Bolt—M8 x 16 mm (2)
8. Turn the machine over and remove the foam.
9. Install the handlebar tube as follows:
A. Rotate the spreader bolt clockwise.
Figure 8
1. Spreader bolt
g361868
2. Pin (2)
g361872
B. Insert the handlebar tube into the red
bracket and secure it as shown.
1. Nut (M8)
2. Handlebar tube
C. Remove and discard the spreader bolt.
D. Tighten the fasteners until the handlebar
tube is snug.
10. On the handlebar assembly, connect the cables
to the drive levers if they are not attached.
1. Rear drive lever cable
8
Figure 9
3. Bolt (M8 x 85 mm)
Figure 10
2. Front drive lever cable
g361867
g361873