SciCan HYDRIM M2 Mantenimiento página 5

Connect solution bottle
Connect machine to appropriate power supply
Install printer/data logger as appropriate
Remove protective film from external surfaces
Clean external surfaces.
Locate and level machine in final position
Measure the water hardness, water conductivity and pH value and compare the results
with the values of the pre-installation Service Advice Sheet SD-354 entitled – "Hydrim M2
Washer Disinfector Pre installation requirements". Set the built-in water softener system
according to the settings recommended in the M2 Operator Manual.
If the test results of any of the water parameters exceed the stated problem levels in the
Service Advice Sheet SD-354, a full water analysis is recommended and the installation of
a water treatment system may be required to achieve satisfying cleaning results with the
Hydrim.
Water Quality
• Water hardness
o Hot water
o Cold water
• Water conductivity
• pH value
NOTE! Before switching on the unit itself:
• Turn on the water supply isolators and check for static leaks.
• Check that power cable, feed pipes and drain tube are not kinked or
compromising each other.
• Ensure power cable is not touching pipes or part of the machine that are
liable to get hot.
• Turn on the power supply at the main connection.
Switch on unit via fascia switch – allow unit to prime (automatic)
Switch off unit
Switch on unit again and touch 'i' to enter menu screen
Select 'Setup' menu and set up the following as appropriate
• Unit number
• Language
• Date/Time
• Screen saver
• Temperature units
• Button 'beep'
• Logger/printer selection as appropriate
• Logger/printer Baud rate
• Regeneration unit
• Screen contrast
On completion of the above, scroll back through menu to main screen. Switch the unit off
via fascia switch.
All manuals and user guides at all-guides.com
4 SD-355