WIKA 910.70 Manual De Instrucciones página 11

5. Commissioning, operation
5.2 Electrical mounting
The power supply unit used for the voltage supply of the instrument must fulfil the
demands on the required power supply, see chapter 9 "Specifications".
For the electrical connection of the instrument, only the original cables delivered from
WIKA for this instrument may be used.
WARNING!
Before commissioning, ensure that the voltage supply is turned off.
Wiring
4
2
1
Sensor input
Female connector: Connection for sensor cable (4-pin)
1. Using the sensor cable, connect the instrument with the sensor
2. Connect the supply cable to the indicator
3. Switch on the power supply
The indicator will be initialised. If the LED lights up green, then the indicator is ready for
use. If the LED flashes green, the output signal is either above or below the scale range.
The LED statuses are described in chapter 6 "Faults".
WIKA operating instructions indicator for panel mounting, model 910.70
Analogue output (optional)
Connector: Connection for supply cable (4-pin)
Cable assignment
4 3
Pin Function
1 Analogue output (+)
2
1
2 Power supply (DC 14 ... 24 V)
3
3 Analogue output (-)
4 Power supply (GND / 0 V)
EN
Wire colour
BN
WH
BL
BC
11