Inputs Outputs - Saci pumps VSD Magnus Manual De Instalación Y Mantenimiento

10 SETUP MENU
6 DISPLAY
Par Description
6.7 Digital input 2
6.8 Relay 1 output
6.9 Relay 2 output
6.10 Software version
6.11 Power consumed by pump
6.12 Power consumed by network
7 LOG
Shows a log of anomalies of the pump where the speed variator is connected, indicating the date, the time
and the anomaly that occurred. This information is very important for detecting possible anomalies in the
functioning of the installation.

8 INPUTS OUTPUTS

Par Description
8.1 Digital input 1
8.2 Input 1 frequency
8.3 Digital input 2
8.4 Input 2 frequency
VSD Magnus - [e]Magnus
34
VALUES
Units
Default Min. Max.
W
W
VALUES
Units
Default Min. Max.
Unused /
Emergency
Unused
stop / Forced
start
Hz 50 10 50
Unused /
Emergency
Unused
stop / Forced
start
Hz 50 10 50
Notes
Indicates whether input 2 is enabled or not;
if it is enabled, the reason for this.
Indicates whether relay 1 is enabled or not;
if it is enabled, the reason for this.
Indicates whether relay 2 is enabled or not;
if it is enabled, the reason for this.
Indicates the version of the software of the
control panel (screen) and the power panel
(aluminium radiator).
Indicates the instantaneous power
consumed by the pump.
Indicates the instantaneous power
consumed by all the pumps that are
operating at that time.
Notes
An input can be enabled to carry out a
remote stop or to force the pump to start,
even though it is out of reach of a filtration
cycle.
Important: Input 1 is a normally open input,
therefore to enable it the contact must be
closed without voltage.
If digital input 1 is activated for forced
operation, you can indicate the frequency at
which you want the pump to function when
the input is enabled.
A second input can be enabled to carry out
a remote stop or to force the pump to start,
even though it is beyond the scope of a
filtration cycle.
Important: Input 2 is a normally open input,
therefore to enable it the contact must be
closed without voltage.
If digital input 2 is activated for forced
operation, you can indicate the frequency at
which you want the pump to function when
the input is enabled.