Installation; Pump Location; Mechanical Installation - HYDROO VDROO Serie Manual De Instrucciones De Instalación Y Operación

Y2 / IE1
50Hz (2 poles)
Motor [kW] LpA [dB(A)]
0,37 – 0,55 47
YE3 / IE3
50Hz (2 poles)
Motor [kW] LpA [dB(A)]
0,75 50
1,1 50
1,5 56
2,2 56
3 62
4 65
5,5 – 7,5 67
11 69
15 69
18,5 69
22 71
30 71
37 71
45 73
55 76
75 77
90 77
110 78
70
LWA [dB(A)]
58
LWA [dB(A)]
61
61
67
67
73
76
78
80
80
80
82
82
82
84
87
88
88
89

5. INSTALLATION

DANGER:
· Follow the safety regulations in force.
· Use adequate personal protective equipment.
· Always check local and domestic regulations and legislation in force
with regards to choosing the installation site as well as electric and
water connections.
· Make sure the connections are made by qualified personnel and in
accordance with the regulations in force.
· Before starting to work with this unit, make sure that the control panel
is isolated from the power supply and cannot be energized. The same
applies to the control circuit.

5.1. Pump location

DANGER:
Do not use this pump in any environment that may contain inflammable
or explosive dust or gas or that may be chemically aggressive.
Some examples of inadequate installation are:
· Dangerous sites such as corrosive or explosive atmospheres.
· Locations with very high temperature or scarce ventilation.
· Outdoor installation without rain or freeze protection

5.2. Mechanical installation

ATTENTION:
The pump must be fixed to a flat and solid horizontal stand by means
of bolts through the holes in the pump base plate. In order to avoid
damages, install the pump according to the procedures below.
1. The arrows on the pump base plate indicate the direction of the flow through it.
2. APPENDIX B shows the following information:
- Flange to flange distances.
- Base dimensions.
- Pipe connection types.
- Supporting bolts diameter and positions.
71