Commissioning - SICK HTE18 Instrucciones De Operación

7

COMMISSIONING

7 Commissioning
16
-xxxxxI Q1 = L.ON
2
-xxxxxD
-xxxxxG
Q1 = D.ON
-xxxxxK
1
Adjustabl
-xxxxxN
e OFF
Delay
-xxxxxK 2 Q1 = L.ON
1 L/D Selection Switch in in the "D" Dark Switching position
2 L/D Selection Switch in in the "L" Light Switching position
1 Alignment Sensor with red light:
Align sensor on object. Select the position so that the red emitted light beam hits the cen‐
ter of the object. You must ensure that the optical opening (front screen) of the sensor is
completely clear [see figure
Sensor with infrared light (not visible):
Align sensor on object. Select the position so that the infrared light hits the center of the
object. The correct alignment can be detected via the signal strength light bar on the back
of the sensor and the LED on the top of the sensor. See
ensure that the optical opening (front screen) of the sensor is completely clear.
Figure 1: Alignment
2 Sensing range
Check the application conditions: Adjust the sensing range and the remission capability of
the object according to the corresponding diagram [see
operating reserve).
During this process, an object can only be detected in front of a background if the remis‐
sion capability of the object is significantly higher than that of the background or if the dis‐
tance between the object and the background is sufficiently long.
1].
table
figure 1 and table 1. You must
10]. (x = sensing range, y =
8017851.16K9 | SICK
Subject to change without notice