Starting The Product; Stopping The Product - Toro 51945 Manual Del Operador

Operation

Starting the Product

See Figures 5 - 7.
Starting the product differs depending on whether the engine
is cold or warm. Refer to the label on the air filter cover.
To Start a Cold Engine:
Follow these steps to start a cold engine.
1. Lay the product on a flat, bare surface.
2. Push the primer bulb eight times.
FULL
3. Set the choke lever to
4. Depress lock-out button and squeeze throttle trigger fully
(thru step 7) and pull starter handle sharply until engine
attempts to start (no more than 4x).
HALF
5. Set the choke lever to
6. Pull starter handle until engine runs, no more than 6
pulls.
RUN
7. Set the choke lever to
NOTE: In cooler environments, additional pulls of the
starter handle may be required with the choke lever in
FULL
the position.
To Start a Warm Engine:
Follow these steps to start a warm engine.
1. Lay the product on a flat, bare surface.
2. Push the primer bulb up to eight times.
RUN
3. Set the choke lever to
4. Depress lock-out button and squeeze throttle trigger
fully, pull the starter cord.
NOTE: If the product does not start, repeat the previous
steps.
Lock-out
Switch
Button
Primer
Throttle
Bulb
Trigger
14
.
.
.
.
Starter
Grip and
Rope
Figure 5
Set Choke to FULL

Stopping the Product

See Figure 7.
Follow these steps to stop the product.
1. Release the trigger.
(STOP)
2. Press on/stop switch to
Throttle
Trigger
Set Choke to RUN
Figure 6
position.
On/Stop
Switch
Figure 7
Operation