Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Starting the Engine
1.
Push up on the engine On/Off switch so it is in
the O
position.
N
2.
Move the fuel-valve lever to the O
3.
Move the choke lever to the C
Note:
A warm or hot engine may not require
choking.
4.
Move the throttle lever to the F
Figure 12
1. Throttle lever in the F
AST
position
2. Fuel-valve lever in the
O
position
PEN
5.
Move the transport lever all the way back toward
you into the transport position
6.
Hold the blade-control bar against the handle
(A of
Figure
13).
7.
From the engine, pull the recoil-start handle (B
of
Figure
13).
Note:
When you pull the recoil-start handle,
pull it lightly until you feel resistance, then pull it
sharply. Allow the rope to return to the handle
slowly.
Note:
If the machine does not start after several
attempts, contact an Authorized Service Dealer.
position.
PEN
position.
LOSED
position.
AST
g356293
3. Choke lever in the C
LOSED
position
4. On/Off switch in the O
N
position
(Figure
10).
8.
After the engine starts, gradually move the
choke lever back to the O
engine stalls or hesitates, move the choke back
to the O
position again until the engine warms
N
up, then move it to the O
Shutting Off the Engine
To shut off the engine, release the blade-control bar
and move the transport lever all the way back toward
you into the transport position
13
Figure 13
position. If the
FF
position.
FF
(Figure
10).
g348516
Capítulos
Tabla de contenido
Solución de problemas
