Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Studio-S
®
Pull-Down Bar Kitchen Faucet
Thank you for selecting American Standard...
the benchmark of fine quality for over 140 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS
Flat Blade Screwdriver
1
INSTALL FAUCET
Turn off water at
CAUTION
main supply
• Make certain the SEAL (1) is properly seated in recess of
spout base.
• Insert all HOSES (2) and SHANK (3) through MOUNTING
RING (4) and mounting surface. Do not use putty.
• Insert HOSES (2) through RUBBER WASHER (5), BRASS
WASHER (6), and threaded LOCKNUT (7).
• Assemble RUBBER WASHER (5), BRASS WASHER (6), and
threaded LOCKNUT (7) onto SHANK (3) from underside
of sink or mounting surface. Hand tighten LOCKNUT (7).
• Use a screwdriver to tighten SCREWS (8) on LOCKNUT (7).
Work your way around LOCKNUT (7), tightening the screws
slightly each time until all are snug to ensure even pressure.
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2019
INSTALLATION
INSTRUCTIONS
Phillips Screwdriver
- 1 -
4803410
Certified to comply with ANSI A112.18.1M
Certified to comply with ANSI A112.18.1M
Adjustable Wrench
SPOUT BASE
2
6
7
Plumbers' Putty or Caulking
4
1
3
2
5
8
M985013 (3/19)
Tabla de contenido
loading

Resumen de contenidos para American Standard Studio-S 4803410

  • Página 4: Herramientas Recomendadas

    ® Llave para cocina con manija para tirar hacia abajo - Barra Gracias por elegir American Standard, el punto de referencia de óptima calidad durante más de 140 años. Para realizar la instalación sin problemas, lea atentamente estas instrucciones antes de comenzar.
  • Página 5: Realizar Las Conexiones De Los Suministros De Agua

    REALIZAR LAS CONEXIONES DE LOS SUMINISTROS DE AGUA RAYA • Apague los suministros de agua caliente y fría antes de comenzar. RAYA AZUL ROJA • Conecte las MANGUERAS FLEXIBLES DE SUMINISTRO (1, 2) directamente a los suministros de la pared. La conexión en los suministros tiene una compresión de 3/8".
  • Página 6: Comprobación De Fugas En Las Conexiones

    COMPROBACIÓN DE FUGAS EN LAS CONEXIONES • Desplace la MANIJA a la posición de cierre. • Abra los suministros del agua y revise si hay fugas en las conexiones. • Mueva la MANIJA hacia arriba y abajo, a izquierda y derecha, para hacer correr el agua por las tuberías.

Este manual también es adecuado para:

Studio-s 803410.075

Tabla de contenido