American Standard Studio-S 4803350 Instrucciones De Instalación
American Standard Studio-S 4803350 Instrucciones De Instalación

American Standard Studio-S 4803350 Instrucciones De Instalación

Llave para cocina semiprofesional
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Studio-S
®
Semi-Profressional Kitchen Faucet
Thank you for selecting American Standard...
the benchmark of fine quality for over 140 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS
Flat Blade Screwdriver
1
INSTALL FAUCET
Turn off water at
CAUTION
main supply
• Make certain the SEAL (1) is properly seated in recess of
spout base.
• Insert all HOSES (2) and SHANK (3) through MOUNTING
RING (4) and mounting surface. Do not use putty.
• Insert HOSES (2) through RUBBER WASHER (5), BRASS
WASHER (6), and threaded LOCKNUT (7).
• Assemble RUBBER WASHER (5), BRASS WASHER (6), and
threaded LOCKNUT (7) onto SHANK (3) from underside
of sink or mounting surface. Hand tighten LOCKNUT (7).
• Use a screwdriver to tighten SCREWS (8) on LOCKNUT (7).
Work your way around LOCKNUT (7), tightening the screws
slightly each time until all are snug to ensure even pressure.
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2019
INSTALLATION
INSTRUCTIONS
Phillips Screwdriver
- 1 -
4803350
Adjustable Wrench
SPOUT BASE
2
6
7
Certified to comply with ANSI A112.18.1M
Plumbers' Putty or Caulking
4
1
3
2
5
8
M985012 (3/19)
Tabla de contenido
loading

Resumen de contenidos para American Standard Studio-S 4803350

  • Página 7: Herramientas Recomendadas

    4803350 Studio-S ® Llave para cocina semiprofesional Gracias por elegir American Standard, el punto de referencia de óptima calidad durante más de 140 años. Para realizar la instalación sin problemas, lea atentamente estas instrucciones antes de comenzar. Certificado de conformidad con la norma ANSI A112.18.1M...
  • Página 8: Conexiones Del Suministro De Agua

    CONEXIONES DEL SUMINISTRO DE AGUA FRANJA • Cierre los suministros de agua caliente y fría antes de comenzar. AZUL FRANJA • Conecte los CONDUCTOS FLEXIBLES (1, 2) directamente a los ROJA suministros de la pared. Las conexiones en los suministros de accesorios tienen 3/8"...
  • Página 9: Prueba De La Llave Mezcladora Instalada

    PRUEBA DE LA LLAVE MEZCLADORA INSTALADA • Mueva la MANIJA (1) a la posición “off”. • Abra los suministros de agua. • Compruebe si las conexiones presentan fugas. (Consulte la Sección 4) • Con la MANIJA (1) en la posición “off”, desenrosque el ROCIADOR (3) de la MANGUERA (2).

Tabla de contenido